Kyocera TASKalfa 305 - Optical Section; Detaching and Refitting the Laser Scanner Unit

2K3/2L3
1-5-23
1-5-9 Optical section
(1) Detaching and refitting the laser scanner unit
Procedure
1. Remove the rear cover and inner
tray.(See page 1-5-5,1-5-6)
2. Remove the connector.
3. Remove the screw and then remove the
power source fan motor.
Figure 1-5-37
4. Remove the connector.
5. Remove four screws and then remove
the laser scanner unit.
6. Check or replace the laser scanner unit
and refit all the removed parts.
Figure 1-5-38
Power source
fan motor
Screw
Connector
Screw
Connector
Screw
Screws
Laser scanner
unit (LSU)