Kyocera TASKalfa 305 - Detaching and Refitting the LED Unit

2K3/2L3
1-5-26
(3) Detaching and refitting the LED unit
Procedure
1. Remove the DP or original cover.
(See page 1-5-28)
2. Remove the sanner right cover and
platen.(See page 1-5-24)
3. Remove the ISU front cover.
Figure 1-5-43
4. Remove two screws and then remove
the ISU rear cover.
Figure 1-5-44
ISU front cover
Screw
Screw
ISU rear cover