2K3/2L3
1-3-3
Developer U140 Displaying developer bias 170/2700/60
U147 Setting for toner applying operation Mode1
U150 Checking sensors for toner -
U157 Checking the developer drive time -
Fuser U161 Setting the fuser control temperature 135/150/165
U199 Displaying fuser heater temperature -
Operation
panel and
support
equipment
U201 Initializing the touch panel -
U203 Checking DP operation -
U207 Checking the operation panel keys -
U222 Setting the IC card type Other
U243 Checking the operation of the DP motors -
U244 Checking the DP switches -
Mode setting U250 Checking/clearing the maintenance cycle -
U251 Checking/clearing the maintenance counter -
U253 Switching between double and single counts Double count
(A3/Ledger)
U260 Selecting the timing for copy counting Eject
U285 Setting service status page On
U326 Setting the black line cleaning indication On/8
U332 Setting the size conversion factor 1.0
U341 Specific paper feed location setting for printing function -
U343 Switching between duplex/simplex copy mode Off
U345 Setting the value for maintenance due indication 0
Image
processing
U402 Adjusting margins of image printing 3.0/2.5/2.5/5.0
U403 Adjusting margins for scanning an original on the contact
glass
2.0/2.0/2.0/2.0
U404 Adjusting margins for scanning an original from the DP 3.0/2.5/3.0/4.0
U407 Adjusting the leading edge registration for memory image
printing
0
U411 Adjusting the scanner automatically -
U425 Setting the target -
U432 Setting the center offset for the exposure 0/0/0
U470 Setting the JPEG compression ratio
Copy
Send
System
90/90
30/40/51/70/90
30/40/51/70/90
15/25/60
15/25/60
90/90
Section
Item
No.
Content of maintenance item
Initial
setting
To Next Page
Loading...
