2K3/2L3
1-3-19
U034
5. Change the setting value using the cursor left/right keys or numeric keys.
For output example 1, increase the value. For output example 2, decrease the value.
Figure 1-3-2
6. Press the start key. The value is set.
Remark
When changing the setting value of [Large] each item is modified, equal to amount of the value
which is changed adds also the value of [Small] each item and is pulled.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following
adjustments in maintenance mode.
Adjustment: Center line adjustment
1. Press the system menu key.
2. Press the start key to output a test pattern.
3. Press the system menu key.
4. Select the item to be adjusted.
Item No. Description
Correct image
Output
example 1
Output
example 2
Leading edge
registration
(20 ± 1.5 mm)
U034
U066
( P.1-3-27)
U071
( P.1-3-32)
Display Description
Setting
range
Initial
setting
Change in
value per step
MPT Paper feed from MP tray -128 to 127 0 0.1 mm
Cassette1 Paper feed from cassette 1 -128 to 127 0 0.1 mm
Cassette2 Paper feed from optional
cassette 2
-128 to 127 0 0.1 mm
Cassette3 Paper feed from optional
cassette 3
-128 to 127 0 0.1 mm
Duplex Duplex mode (second) -128 to 127 0 0.1 mm
To Next Page
Loading...
