Kyocera TASKalfa 3550ci - Page 241

2LK/2LN/2LM/2LC-2
1-3-147
U340 Setting the applied mode
Description
Allocates memory to ensure that there is sufficient memory available for the printer to use as a
working area.
Purpose
Modify the memory allocation if insufficient memory for transparency support or XPS direct print-
ing occurs.
Method
1. Press the start key.
2. Select the item to set.
Setting: [Adj Memory]
1. Change the setting using the +/- keys or numeric keys.
Set the values below in case print failure occurs with the memory shortage.
(recommended value)
Image : +190
Image(Detaile) : +1
2. Press the start key. The value is set.
3. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
Supplement
The work area for copy is small and it may cause output failure if the values are large.
Setting: [Adj Max Job]
1. Change the setting using the +/-keys or numeric keys.
The maximum Printer jobs should be (maximum jobs) – (maximum copy jobs).
2. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Item No. Description
Display Description
Adj Memory Setting the memory allocation
Adj Max Job Setting the maximum of multiple jobs
Display Description
Setting
range
Initial
setting
Image Area temporarily used to create output
image.
0 to 400 (MB) 0
Image(Detail) Area temporarily used to hold down-
loaded font and other data.
0 to 400 (MB) 0
Display Description
Setting
range
Initial
setting
Copy Maximum copy (Scan To Print) Jobs 10 to 50 10
Printer Maximum printer (Host To Print) Jobs 10 to 50 -