Kyocera TASKalfa 3550ci - (2) Maintenance modes item list

2LK/2LN/2LM/2LC-2
1-3-2
(2) Maintenance modes item list
Section
Item
No.
Content of maintenance item
Initial setting
30ppm 35ppm 45ppm 55ppm
General U000 Outputting an own-status report -
U001 Exiting the maintenance mode -
U002 Setting the factory default data -
U003 Setting the service telephone number -
U004 Setting the machine number -
U010 Setting the maintenance mode ID -
U019 Displaying the ROM version -
Initializa-
tion
U021 Memory initializing -
U024 HDD formatting -
Drive,
paper feed
and paper
conveying
system
U030 Checking the operation of the motors -
U031 Checking switches and sensors for paper
conveying
-
U032 Checking the operation of the clutches -
U033 Checking the operation of the solenoids -
U034 Adjusting the print start timing
LSU Out Top 0/0/0/0/0/0/0/0/0/0/0/0
LSU Out Left 0/0/0/0/0/0/0 0/0/0/0/0/0/0/0/0
LSU Out Top B/W - 0/0/0/0/
0/0
LSU Out Top 3/4 0/0/0/0/0/0
U035 Setting the printing area for folio paper 330/210
U037 Checking the operation of the fan motors -
U039 Adjusting the magnification 0
U051 Adjusting the deflection in the paper
Paper Loop Amount 1/1/1/1/1/1 -5/0/-5/
0/-5/0
-7/-1/-7/
-1/-7/-1
Paper Loop Amount B/W - -8/-8/-8
Paper Loop Amount 3/4 1/1/1 -2/-2/-2
U052 Setting the fuser motor control
Set Loop Sensor -
Loop Sensor Control On/On/On/On
Set Loop Sensor Valid On
U053 Setting the adjustment of the motor speed
Moter1 0
Moter2 0/0/0/-/0
0/0/0/0/0