Kyocera TASKalfa 3550ci - (3) Detaching and refitting the power source PWB

2LK/2LN/2LM/2LC
1-5-56
(3) Detaching and refitting the power source PWB
Procedure
1. Remove the rear lower cover (see page
1-5-65).
2. Release three wire saddles.
3. Remove four connectors.
Figure 1-5-87
4. Release six wire saddles.
5. Remove the following eleven connec-
tors and three tabs from the power
source PWB.
YC3
YC1
TB1
TB2
TB5
YC7
YC8
YC17
YC14
YC12
YC16
YC13
YC10
YC11
Figure 1-5-88
Wire saddle
Wire saddle
Waire saddle
Connector
Connector
Connectors
YC3
YC17
YC14
YC12
YC16
YC13
YC10
YC11
YC1
YC7
YC8
TB5
TB1
TB2
Power source assembly
Power source PWB
Power source PWB
Wire saddle
Wire
saddles
Wire saddles