Kyocera TASKalfa 3550ci - (1) No image appears (entirely white).

2LK/2LN/2LM/2LC
1-4-93
(1) No image appears (entirely white).
Print example Causes Check procedures/corrective measures
Defective
transfer
bias output.
Defective connector cable
or poor contact in the con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
High voltage PWB 2 (YC1) and engine PWB
(YC8)
Defective high voltage PWB
2.
Replace the high voltage PWB 2
(see page 1-5-60).
Defective engine PWB. Replace the engine PWB (see page 1-5-54).
Defective
developer
bias output.
Defective connector cable
or poor contact in the con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
High voltage PWB 1 (YC1, 2) and engine
PWB (YC16)
High voltage PWB 1 (YC3, 4) and engine
PWB (YC17)
Defective high voltage PWB
1.
Replace the high voltage PWB 1
(see page 1-5-59).
Defective engine PWB. Replace the engine PWB (see page 1-5-54).
No LSU
laser is out-
put.
Defective laser scanner
unit.
Replace the laser scanner unit
(see page 1-5-25).
Defective engine PWB. Replace the engine PWB (see page 1-5-54).