Kyocera TASKalfa 3550ci - Page 379

2LK/2LN/2LM/2LC-2
1-4-81
8210 DF slide motor error
When initial operation, DF sta-
ple sensor does not turn on
within 3 s.
Defective connec-
tor cable or poor
contact in the con-
nector (4000-sheet
finisher).
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
DF slide motor and DF main PWB (YC12)
DF staple sensor and DF main PWB (YC22)
Defective connec-
tor cable or poor
contact in the con-
nector (1000-sheet
finisher).
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
DF slide motor and DF main PWB (YC10)
DF staple sensor and DF main PWB (YC20)
Defective DF sta-
ple sensor.
Replace the DF staple sensor.
Defective DF slide
motor.
Replace the DF slide motor.
Defective DF main
PWB.
Replace the DF main PWB and check for
correct operation.
8230 DF staple motor error 1
JAM7000 is detected twice.
Defective connec-
tor cable or poor
contact in the con-
nector (4000-sheet
finisher).
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
Staple unit and DF main PWB (YC17)
Defective connec-
tor cable or poor
contact in the con-
nector (1000-sheet
finisher).
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
Staple unit and DF main PWB (YC11)
Defective DF sta-
ple sensor.
Replace the staple unit.
Defective DF sta-
ple motor.
Defective DF main
PWB.
Replace the DF main PWB and check for
correct operation.
Code Contents Causes
Check procedures/
corrective measures