2LK/2LN/2LM/2LC-2
1-2-15
3. Remove the operation panel sheet.
4. Replace the operation panel sheet of
the corresponding language.
5. Refit the clear panel.
6. Refit the operation panel covers A and
B.
Figure 1-2-21
1. Install optional original platen or DP.
1. Install the optional devices (job separa-
tor, document finisher and/or fax kit
etc.) as necessary.
1. Install the optional cassette heater as
necessary (see page 1-2-64).
1. Connect the power cord to the power
cord connector on rear lower of the
machine.
2. Connect the power plug to the wall out-
let.
Operation
panel sheet
Installing the original platen or DP (option)
Installing other optional devices
Installing the cassette heater (option)
To Next Page
Loading...
