Kyocera TASKalfa 3550ci - Page 426

2LK/2LN/2LM/2LC
1-5-8
Figure 1-5-10
6. Pull the primary paper feed shaft out
from the forwarding pulley holder.
7. Remove the feed gear Z30H OW and
paper feed pulley.
*: To refit the feed gear Z30H OW, be sure
to correctly align it with the paper feed
pulley, so that the on-way clutches meet
each other.
Figure 1-5-11
8. Pull the forwarding pulley from the axis
hole of forwarding pulley holder.
Figure 1-5-12
Primary paper feed shaft
Feed gear
Z30H OW
Feed gear
Z30H OW
Oneway
clutch
Paper feed pulley
Paper feed pulley
Forwarding
pulley holder
Forwarding pulley
Gear
Axis hole
Axis hole
Forwarding pulley holde
r