Kyocera TASKalfa 3550ci - Page 648

2LK/2LN/2LM/2LC
2-3-98
YC8
26 DATA_1P_M(LVD
S)
O 0/3.3 V DC (pulse) Video data signal M (P)
Connected to
APC PWB M
27 SGND - - Ground
28 DATA_2N_M(LVD
S)
O 0/3.3 V DC (pulse) Video data signal M (N)
29 DATA_2P_M(LVD
S)
O 0/3.3 V DC (pulse) Video data signal M (P)
30 SGND - - Ground
YC9
1 24V O 24 V DC 24 V DC power to PM-C
Connected to
polygon
motor C
2PGND -- Ground
3 REM C O 0/24 V DC PM-C: On/Off
4 LOCK C I 0/3.3 V DC PM-C lock signal
5 CLK C O 0/3.3 V DC (pulse) PM-C clock signal
YC10
1SGND -- Ground
Connected to
APC PWB C
2 BD C I 0/3.3 V DC (pulse) Horizontal synchronization signal C
3 LSU_TH C I Analog LSU thermistor C detection signal
4 - - - Not used
5 - - - Not used
6 5V O 5 V DC 5 V DC power to APCPWB-C
7 5V O 5 V DC 5 V DC power to APCPWB-C
8 5V O 5 V DC 5 V DC power to APCPWB-C
9 LDD_CS 1 C O 0/3.3 V DC APCPWB-C control signal
10 SDI1 I 0/3.3 V DC (pulse) Serial communication data signal
11 SDO1 O 0/3.3 V DC (pulse) Serial communication data signal
12 CLK1 O 0/3.3 V DC (pulse) APCPWB-C clock signal
13 EEPROM CS C I/O 0/3.3 V DC (pulse) APCPWB-C EEPROM data signal
14 MSET_N O 0/3.3 V DC APCPWB-C control signal
15 CUALM C I 0/3.3 V DC APCPWB-C alarm signal
16 - O 0/3.3 V DC APCPWB-C control signal
17 INT_ST 1 C O 0/3.3 V DC APCPWB-C control signal
18 PALA_SIG P0 C O 0/3.3 V DC APCPWB-C control signal
19 PALA_SIG P1 C O 0/3.3 V DC APCPWB-C control signal
20 PALA_SIG P2 C O 0/3.3 V DC APCPWB-C control signal
21 PALA_SIG P3 C O 0/3.3 V DC APCPWB-C control signal
22 PALA_SIG P4 C O 0/3.3 V DC APCPWB-C control signal
23 SDCLK C O 0/3.3 V DC (pulse) APCPWB-C clock signal
24 GAIN FIX C O 0/3.3 V DC APCPWB-C control signal
Connector Pin Signal I/O Voltage Description