Kyocera TASKalfa 3550ci - Page 81

2LK/2LN/2LM/2LC-2
1-2-57
12. Connect the connector of the PHS sig-
nal cable to the connector YC2 on the
KMAS interface PWB.
13. Refit the rear upper cover.
Figure 1-2-74
14. Fit the PHS module to rear upper cover
using two M3 x 16 screws.
Figure 1-2-75
YC2
PHS signal
cable
KMAS
interface PWB
Rear upper cover
PHS module
M3 x 16 screws