3 SETTING OPTIONS
Setting up the N/W-Fax Options 21
Setting up the N/W-Fax Options
N/W-Fax options are the attributes to define the way a fax job is transmitted. For example, you can specify the recipients,
resolution, and paper size.
For additional instructions concerning these fax transmission settings, refer to the procedures in the following section.
P.24 “Sending with Extended Fax Functionality”
Setting the Send properties
In the [Send] tab of the [N/W-Fax properties] dialog box, you can specify the recipients and how the fax will be sent.
To specify the recipients, you can select from the address book or enter the recipient manually.
P.11 “Specifying recipients”
1) To
This displays the specified recipients list.
2) [Select From Address Book]
Click to launch the AddressBook Viewer. You can select recipients from the address book.
P.11 “Specifying recipients from address book”
To use the address book, you must register the contacts using the AddressBook Viewer.
3) [New]
Click to add new recipient by entering manually. The [Direct Dial] dialog box appears.
P.17 “Entering a recipient manually”
4) [Remove]
Select a recipient in the [To] list and click this to remove the recipient from the list.
P.18 “Removing recipients”
5) Resolution
Select the resolution for the fax.
- Standard (200 x 100 dpi)
— Select this to send a document in Standard mode (200 x 100 dpi).
- Fine (200 x 200 dpi) — Select this to send a document in Fine mode (200 x 200 dpi).
- Super Fine (200 x 400 dpi) — Select this to send a document in Super Fine mode (200 x 400 dpi).
- Ultra Fine (400 x 400 dpi) — Select this to send a document in Ultra Fine mode (400 x 400 dpi).
6) Dept. Code
Enter 5-digit department code if required. When the department code is enabled on this equipment, you must enter the
department code to send a fax.
To Next Page
Loading...
