Scanner Settings
1-8
Border Erase
Removes black borders from around the edges of originals.
Continuous Scan
After scanning an original, you can continue scanning a new original. When this feature is enabled,
after an original is scanned, a selection screen prompts whether to continue scanning originals.
NOTE: For TWAIN image scanning, Continuous Scan is available when Wait for Scan is enabled.
Function Value Description
Border Erase Sheet Inch models
Border: 0 - 2" (1/8" increments)
Metric models
Border: 0 - 50 mm
Use this mode to erase black borders
around single sheet originals.
Book Erase Inch models
Border: 0 - 2" (1/8" increments)
Gutter: 0 - 2" (1/8" increments)
Metric models
Border: 0 - 50 mm
Gutter: 0 - 50 mm
Use this mode to erase black borders that
develop around the edges and in the
middle when scanning originals such as
thick books. You can specify the widths
individually to erase the borders around
the edges and in the center of the book.
Individual
BordrErase
Inch models
Top: 0 - 2" (1/8" increments)
Bottom: 0 - 2" (1/8" increments)
Left: 0 - 2" (1/8" increments)
Right: 0 - 2" (1/8" increments)
Metric models
Top: 0 - 50 mm
Bottom: 0 - 50 mm
Left: 0 - 50 mm
Right: 0 - 50 mm
Use this mode to individually specify
border widths to erase on all sides.
Off Do not erase borders.
Item Description
On Enables Continuous Scan.
Off Disables Continuous Scan.
To Next Page
Loading...
