Kyocera TASKalfa 820 - Selec. of Senders (Users)

Scanner Settings
1-16
Selec. of senders (Users)
When using this scanner, a sender (user) must be first selected. Set Selec. of senders (users) to set
the sender (user) to User No. 001 and skip the sender (user) selection step. Use this setting to limit
scanner usage to certain users or to skip this operation step.
NOTE: When enabling Selec. of senders (users), be sure to register a user to User No. 001.
1
Referring to Accessing the Setting default function Screen on page 1-11, access the Setting default
function screen.
2
Press [] or [] to select Selec. of senders (users) and press [Change #].
3
Select [On] or [Off].
4
Press [Close]. The display returns to the Setting default function screen.
Input E-Mail Address
When sending E-mail, specify whether to directly enter the mail address when selecting recipients.
If set to [Do not use], recipients must be pre-registered in an address book.
1
Referring to Accessing the Setting default function Screen on page 1-11, access the Setting default
function screen.
2
Press [] or [] to select Input E-mail Address and press [Change #].
3
Select [On] or [Off].
4
Press [Close]. The display returns to the Setting default function screen.
Item Description
On Skips sender user selection and transmits as the user registered to User No.
001.
Off Displays the sender (user) selection screen.
Item Description
On Shows [Enter dest.] during recipient selection. Press this key to manually enter
a mail address.
Off Does not show [Enter dest.] during recipient selection.