Included Scanner Tools
3-18
System Setting
Configure the scanner’s basic settings.
System Basic Setting
Set the scanner’s network settings such as the IP address.
Network 1 Tab
Item Description
Network 1/Network
2/IP-Filters Tab
Switch between Network 1, Network 2, and IP-Filters settings.
Host Name Input a scanner host name no longer than 32 characters.
IP Address Enter the scanner interface IP address in ‘XXX.XXX.XXX.XXX’ notation. A
change verification dialog box is displayed when settings are saved. Verify the
IP address.
Subnet Mask Enter the scanner interface subnet mask in ‘XXX.XXX.XXX.XXX’ notation.
Default Gateway Enter the scanner default gateway in ‘XXX.XXX.XXX.XXX’ notation. The
default gateway is used to transfer packets to other networks or subnets.
DHCP/BOOTP Set DHCP and BOOTP to either ON or OFF. The default setting is ON.
RARP Set RARP to either ON or OFF. The default setting is ON.
ARP/PING Set ARP/PING to either ON or OFF. The default setting is ON.
DNS Server
(Pri.)
For sending data using host names in environments that have DNS servers
available, enter the primary DNS server IP address in this field in
‘XXX.XXX.XXX.XXX’ notation.
DNS Server
(Sec.)
Enter the secondary DNS server IP address in ‘XXX.XXX.XXX.XXX’ notation.
DNS Domain Name Enter the domain name in less than 32 characters.
WINS Server
(Pri.)
To use WINS (Windows Internet Name Service) to resolve computer names
from IP addresses, enter the primary WINS server IP address in
‘XXX.XXX.XXX.XXX’ notation.
WINS Server
(Sec.)
Enter the secondary WINS server IP address in this field in
‘XXX.XXX.XXX.XXX’ notation.
Scope ID Enter the Scope ID in this field.
To Next Page
Loading...
