3-152
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
43
Connect three connectors [A] (only two were connected) from [DF] position to [ST]
position. (Harness Clamp x2)
44
Attach the upper rear cover with 8 screws. These screws are used in Step 39.
45
Attach the exit unit [A] (Screw x4, Connector x1). This screw is used in Step 36.
46
Install the exit roller Assy [A] (Screw x4). These screws were used in Step 34.
To Next Page
Loading...
