Kyocera Taskalfa Pro 15000c - Page 228

3-150
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
37
Remove the vertical conveying guide [A] (Screw x1). This screw is used in step 38.
38
Reposition the vertical conveying guide [A] as shown while aligning the rear
projection [B] with the frame. This screw is used in step 37.
39
Remove the upper rear cover [A] (Screw x8). These screw are used in Step 44.
[A]
[A]
[B]
[A]