Kyocera Taskalfa Pro 15000c - Page 265

3-187
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
145
Assemble the ground plate [A] and a screw bundled in AK-9120 (Screw x1: M4x8).
146
Remove rear upper cover [A] (Screw x3). The screw will use in step 149.
147
Cut off the part [B] in rear upper cover [A]. The part [B] will not be used again.
NOTE
• This procedure does not need in case that the punch unit (PH-7A/7C/7D) has been installed.
[A]
[A]
[A]
[A]
[B]