Kyocera Taskalfa Pro 15000c - Page 300

3-222
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
11
Attach the ACCESS.BAND [A] to the position A and tighten the cable with the band.
Cut the extra band
12
Attach the cover that took off at step 2 (Screws x9).
13
Attach the Right Rear Upper cover that took off at step 1 (Screw x8).
14
Put DVI cable [B] to cut off part [A] of fiery plate. The cut off part position [C] has to be
as shown in picture.
[A]
[B]
[A]
[B]
[C]