Kyocera Taskalfa Pro 15000c - Page 301

3-223
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
15
Attach Fiery plate [A] to the rear lower cover [B] (Screw x2). Fix ACCESS.EDGING [C]
to fiery plate [A] by pushing it. Screw was removed in step 3.
16
Secure the DVI cable [B] onto Printing System 50 [C] with 2 screws [A]. Connect LAN
cable [D] to Printing System 50 [C] and connect another side to network connector.
Connect the power cord [E] to Printing System 50 [C] and connect another end to a
power outlet.
[C]
[B]
[A]
[C]
[E]
[D]
[C]
[A]
[B]