In the design variant the vehi-
cles are provided with power save
function for interior illumination and,
during continuous illumination, it
switches off their power supply.
When switching the ignition off the
time countdown of voltage supply to
these devices starts – the power sav-
ing circuit delay. The delay value is
programmed via the diagnostic inter-
face at the SSNE and may be set
from 5 to 40 minutes. Initially, the
default delay is 10 seconds. After the
delay, the voltage on the listed illumi-
nation devices is switched off. After
voltage disconnection, you can res-
tart the delay by opening any door or
by switching the ignition on and off.
Sun visors
Depending on the direction of
sunbeams, the sun visors can be set
from position I (Fig. 19) to positions II
or III. In the design variant, there is
a vanity mirror on the inside of the
passenger sun visor.
Glove box
To open the glove box cover you
should pull the lock key-button 2
(Fig. 20) and then open cover 1.
Socket for additional electrical
equipment connection
In the design variant, the socket
for additional electrical equipment
connection (Fig. 21a) is installed in
the vehicle that is used for connection
of only 12-volt electrical appliances
with power output of at most 120 W.
In the design variant, the ciga-
rette lighter (Fig. 21b) instead of the
socket is installed in the vehicle for
additional electrical equipment con-
nection.
To use the cigarette lighter, press
the socket button until it is fixed. In
about 20 seconds, the socket auto-
29
Fig. 20. Glove box Fig. 21a. Socket for additional
electrical equipment connection
(in the design variant)
Fig. 19. Sun visor