The selection and use of bits is a very extensive subject, and there have been many books
written on the subject. This section of the manual is intended as a general guide only.
Using the correct bit is important. Several factors need to be considered when choosing the
Correct bit or bits for an application.
Size of hole, diameter, and depth.
Depth of desired hole.
Material of stock to be drilled (hardness, pitch, grain, voids, etc.)
Material and/or coating of bit.
Sharpness of bit.
Bits can break from over-feeding of bit, being dull, incorrect RPM, “skipping” of the bit as it is
introduced into the stock, especially if drilling at an angle.
1.
Disconnect the power to the drill press.
2.
Using the key, loosen the chuck.
3.
Place the bit into the center of the chuck.
4.
Tighten the chuck, using the key or hand pressure.
5.
Place the key into the magnetic key-holder on the left side of the headstock.
Always replace the key into the magnetic key holder after every use.
Never leave key in chuck, as it could cause injury or catch clothing.
NOTE: Key must be inserted into magnetic key holder for Auto Start Function to engage.
To Next Page
Loading...
