Drill Press will not start:
1.
Check that the electrical power cord is plugged into the power outlet.
2.
Check that the start switch is fully lifted (back of headstock).
3.
Check that the yellow safety plug is fully engaged (back of headstock).
4.
Check that the red E-Stop button is disengaged (front of headstock).
5.
Check that the ON switch on the Control Panel has been turned on and is lit up.
6.
Check that the electrical supply is on (reset the breaker).
7.
Check that you have the correct power, 110-120V, 15 amp (min.).
The machine will not stop:
This is a rare occurrence, as the machine is designed to be fail-safe. If it should occur, and
you cannot fix the fault, seek professional assistance. The machine must be disconnected
from the power and not run until the fault has been rectified.
1.
Stop switch faulty. Replace the stop switch.
2.
Internal breaker faulty. Replace the breaker.
Bit overheats:
1.
Dull bit. Replace the bit or sharpen the bit.
2.
Excessive RPM for application, reduce RPM.
3.
Excessive penetration speed, slow bit advancement.
4.
Use of lubricant required for type of drilling/application.
5.
Incorrect type of bit for the application, change to correct bit type.
Machine vibrates:
1.
Machine not level on the floor. Re-level the machine ensuring that it has no movement.
2.
Bearings worn, replace bearings.
Error Codes:
See “Error Codes -Control Panel”, page 32.
To Next Page
Loading...
