Laguna Tools PP16 XC Pro

Need help?

Do you have a question about the Laguna Tools PP16 XC Pro and is the answer not in the manual?

Summary

1. INFORMATION

1-1 General Information

1-2. Safety Rules

Essential safety precautions and procedures for operating the machine safely.

2. MACHINE INFORMATION

2-2. SPECIFICATIONS

Comprehensive technical specifications and performance data for the panelsaw.

3. INSTALLATION

3-2 Fitting the foot brake

3-3.FITTING THE SLIDING TABLE

Instructions on how to correctly assemble and mount the sliding table unit.

3-4. FITTING THE CROSSCUT FRAME & EXTENSION FENCE ASSEMBLY

Procedure for assembling and attaching the crosscut frame and extension fence.

3-5. FITTING MOTORIZED RIP FENCE & EXTENTION TABLE

Steps to install the motorized rip fence and the associated extension table.

3-6. OVERHEAD SAW BLADE GUARD AND CONTROL PANEL FITTING

Guide for installing the overhead saw blade guard and control panel assembly.

3-7. FITTING THE SAW BLADE

Detailed steps for safely installing or replacing the main saw blade.

3-8. RIVING KNIFE

3-9. CHANGING SCORING BLADE

Steps for safely removing and installing the scoring blade.

3-12. CONNECTION TO THE DUST COLLECTION

Guide for connecting the machine to a dust collection system for operation.

3-13. WIRING & TEST RUN

Instructions for wiring the machine and performing initial operational tests.

4. OPERATION

4-1. SAW BLADE LIFTING AND TILTING

Procedures for adjusting the saw blade's vertical lift and tilt angle.

4-2. SCORING BLADE ADJUSTING

Guide for adjusting the scoring blade's height and alignment.

4-3. CONTROL PANEL OPERATION

Guide to operating the machine via its control panel interface.

4-4. 3 SPEED CHANGE

4-5. SETTING THE RIP FENCE UNIT FOR PARALLEL CUTS

4-6. SLIDING TABLE

4-7 SETTING THE CROSSCUT FENCE

I. SQUARE CUTTING TEST

III. RULE ADJUSTING FOR OBLIQUE CUTS

5. MACHINE MAINTAINESS

5-1. Machine cleaning & check

5-2. PERIODICAL LUBRICATION

5-3. REPLACING BELT

II. REPLACING THE SAW SPINDLE BELTS

Operation Manual for Automatic Rip Fence (Optional)

■ A. Grooves;concealed cuts

■ B. Incremental dimension

■ C. Dimension repeat

■ F. Calibration

Trouble Shooting