Laguna Tools PP16 XC Pro - Position of Fence Plate

4. OPERATION
32
II. POSITION OF FENCE PLATE
1. Vertical position (Fig. 4-5.4a) turn to the work piece
2. Horizontal position (Fig. 4-5.4b) for cutting thin work piece and for slanting cuts.
It will be safer to move the work piece forwards by using pusher.
NOTE:
When rip fence has some problem not able use control panel to move it , press A
button to move the rip fence manually (Fig. 4-5.4a)
NOTE:
For the execution of special working, the operators are obliged to put his
hands near the tools. However, based on safety reasons, they could use a
proper pusher to move the work piece forwards, push it against the fence or
to move it away after cutting.
A
(Fig. 4-5.4a) (Fig. 4-5.4b)