3. INSTALLATION
26
3-12. CONNECTION TO THE DUST COLLECTION
The connection to the dust collection is necessary for the good machine operation.
Always work with the dust collector in operation.
The saw is equipped with two dust ports connected to a dust collection system
before operation.
1. Exhaust pipe ( Fig. 3-12.1) diameter 120mm
2. Ex
haust pipe (Fig. 3-12.2) diameter 100mm
If other machines are connected to the centralized collection system, carry out a test
with all collection system in operation.
The right operation of the collection system reduces the risks of dust inhalation.
Figure 3-12.1
Figure 3-12.2
To Next Page
Loading...