Trouble Shooting
Before find out the problem,
can change to manual by press
the bottom at the right hand
size of the rip fence body to
release the lock , can push the
rip fence.
49
Problem Possible cause Trouble shooting
Measure the exact size of the
cut piece then Press the CAL
key for more than 3 seconds to
reset the correct input press
CAL key for another 3 sec. to
set
Possible the rip fence scale is
out of calibration or was set
up incorrect
The rip fence scale is not
accurate
The rip fence can not move
(4)
Connection Problem or the
parts been damage
The rip fence can not move
(3
)
the screen has highlight
and flashing
Possible reason: the travel
distance set up is more
than 1350mm (max. travel
distance)
Press the bottom at the right
hand side of the rip fence to
release and move the rip
fence forward manually
(back to the travel distance)
or press M- key at the
screen continually to let the
rip fence move backward.
No Screen
Po
wer did not connect
properly
Check your power supplier ,
switch
The rip fence can not move (1)
the screen has highlight and
flashing
Possible reason: the travel
distance is less than safety set
up at 400mm,
The rip fence travel distance
from 5mm to 1350mm, safety set
up sensor at 400mm. If the travel
distance set at 300mm, it will
stop at 400mm first , press start
key continually to reach 300mm
The rip fence can not move
(2)
the screen has highlight
and flashing
Possible reason, the set up
distance is less than the
safety set up (to close to
the blade less than 3mm)
so it stop and flash
Press the bottom at the right
hand side of the rip fence to
release and move the rip
fence manual backward out
of the safety distance or
press M+ key at the screen
continually to let the rip
fence move backward.
To Next Page
Loading...