Fusion 3 Table Saw \ Electrical Safety \
If this information is different than what is stated on the Motor Specification Plate - omit this
information. It is possible that the documentation is outdated to a machine change - such as a
different motor.
Always
check
the
motor
plate
prior
to any
wiring.
If
any
doubts, please consult a
certified electrician.
Know when to use a time delay fuse! AKA Slow blow fuse.
Generally, if the motor uses a start capacitor, a time delay fuse is required. This type of fuse
(circuit breaker) will not trip with the initial amperage needed to start the machine, which is typically double that of the
running amperage.
Most woodworking machines use this type of fuse.
Running on Low voltage will damage the machine. Never run the machine in wet or damp
conditions.
For a detailed wiring diagram please see the Wiring Diagram
section at the end of this
manual.
To Next Page
