Fusion 3 Table Saw \ Electrical Safety \
Electrical
Safety
Power
Connections
A separate electrical circuit should be used for your machines. This circuit should not be less than the wiring listed below
and should be protected with an appropriate circuit breaker based on the total running and start-up amperage's (listed
below). If an extension cord is used, use only 3-wire extension cords which have 3-prong grounding type plugs and
matching receptacle which will accept the machine’s plug.
Before connecting the machine to the power source, make sure the switch is in the “OFF”
position.
Below are RECOMMENDATIONS to be used for this machine based on the above
information. Variables outside of our control are:
Actual voltage supplied to the machine
Electrical code that must be met in your local province.
An
electrician
will
verify
that
all
the
demands
are
met
to
properly
wire
the
machine.
If
you
have
absolutely any doubt when wiring this machine - please consult with a qualified electrician.
20AMP / (20 AMP Slow Blow)
Below are RECOMMENDATIONS to be used for this machine based on the above
information. Variables outside of our control are:
Actual voltage supplied to the machine
Electrical code that must be met in your local province.
An
electrician
will
verify
that
all
the
demands
are
met
to
properly
wire
the
machine.
If
you
have
absolutely any doubt when wiring this machine - please consult with a qualified electrician.
20AMP / (20 AMP Slow Blow)
To Next Page
Loading...
