Fusion 3 Table Saw \ Setup \ Accessory Installation
Attaching hose to blade guard assembly: Attaching hose to dust port:
Attaching
the
Fence
Hooks
to
the
Table:
1.
Locate the fence hook bolt holes on the back of the table saw (located underneath the rear extension table).
2.
Thread the fence hook’s hex bolts through the fence hook’s bolt holes.
3.
Thread the hex bolts through the bolt holes on the back of the table saw.
4.
Tighten the hex bolts with the general wrench.
Fence Hook Installation Fence Hook Installation
Tool Caddy:
The table saw’s tool caddy is located under the right extension table. The tool caddy provides a space to store the miter
gauge, the writing knife, and the blade wrench, and the general wrench when not in use.
See the picture shown below to see proper placement of these tools.
To Next Page
