Fusion 3 Table Saw \ Safety \
Important
Safety
Instructions
Read and understand all warnings and operating instructions before using this equipment.
Failure to follow all instructions listed below, may result in electric shock, fire, and/or serious personal injury or property
damage.
Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, there are
certain hazards involved with the operation of the product. Using the machine with respect and caution will considerably
lessen the possibility of personal injury. However, if normal safety precautions are overlooked or ignored, personal injury to
the operator may result. Safety equipment such as guards, push sticks, hold-downs, feather boards, goggles, dust masks
and hearing protection can reduce your potential for injury. But even the best guard won’t make up for poor judgment,
carelessness or inattention. Always use common sense and exercise caution in the workshop. If a procedure feels
dangerous, don’t try it. Figure out an alternative procedure that feels safer. REMEMBER: Your personal safety is your
responsibility.
This machine was designed for certain applications only. We strongly recommend that this machine not be modified
and/or used for any application other than that for which it was designed. If you have any questions relative to a particular
application, do not use the machine until you have first contacted the manufacturer to determine if it can or should be
performed on the product.
If you have any questions relative to its application do not use the product until you have contacted the manufacturer and
we have advised you.
General
Safety
Rules
FAILURE
TO
FOLLOW
THESE
RULES
MAY
RESULT
IN
SERIOUS
PERSONAL
INJURY.
FOR
YOUR
OWN
SAFETY,
READ
AND
UNDERSTAND
THE
INSTRUCTION
MANUAL
BEFORE
OPERATING
THE
MACHINE.
Learn the unit’s application and limitations as well as the specific hazards peculiar to it.
KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
DON’T USE IN DANGEROUS ENVIRONMENT. Don’t use this unit in damp or wet locations or expose it to rain. Keep work
area well-lighted.
KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept a safe distance from work area.
DISCONNECT UNIT before servicing.
CHECK DAMAGED PARTS. Before further use of the unit, properly repair or replace any part that is damaged.
CSA
Required
Safety
Information:
Table
Saws
For Your Own Safety Read Instruction Manual before Operating Tablesaw.
a) Never place your hands in the vicinity or in line with the saw blade.
b) "Wear eye protection" or the sign M004 of ISO 7010.
c) Always use a properly functioning saw-blade guard, riving knife and anti-kickback device for every
operation for which it can be used, including all through sawing.
d) Use a push-stick or push-block when required.
e) Do not perform any operation freehand.
f)
Pay particular attention to instructions on reducing risk of kickback.
g) Never reach around or over saw blade.
h)
Turn off tool and wait for saw blade to stop before moving workpiece or changing settings.
i)
Never stand directly in line with the saw blade. Always position your body on the same side of the saw
blade as the fence.
In addition, use hearing protection and wear gloves when handling saw blades.
To Next Page
Loading...
