14
OPERATIONS
5.1
•
SWITCH ON
Press button 15 for 3 seconds. Whenever
a symbol appears in the anomalies display
(display 7-9) see the “Selfdiagnosis and
anomalies key” chapter.
Note: cooking in manual mode with
several phases in sequence allows the
pre-heating of the empty cooking chamber
before cooking: just set the cycle time 1
at infinite [ InF ]. On reaching the pre-
heat temperature, a cyclic acoustic signal
and [ LoA ] on the display inform that is
time to use the oven. When the door is
closed, the Cycles button 1 displays the
second LED (2) flashing, which indicates
activation of the cooking cycle 2.
5.2
•
SELECT
The cooking mode buttons LEDs flash:
press the button of the desired cooking
mode (2 - 3 - 4). The selected cooking
mode LED will remain on with a fixed light.
5.3
•
SET THE TEMPERATURE OF
CYCLE 1
Turning knob 8 sets the cooking
temperature, which is shown on the
relevant display.
5.4A • SET THE TIME FOR CYCLE 1
The time display shows [ InF ].
Turn knob 10:
to the right to set the cooking time;
to the left to set infinite time, [ InF ] thus
utilizing the first cycle as preheating.
Or
5.4B • SET THE CORE PROBE
FOR CYCLE 1
Refer to “Setting the core probe”.
5.5
•
SELECT CYCLE 2 AND THE
FOLLOWING ONES
(UP TO 4 CYCLES)
Press the cycles button 1, the second
flashing LED (2) switches-on on the
cycles button. Proceed with setting as per
paragraph 5.2. If other phases are desired,
follow the same sequence.
5.6 • SETTING A NEW COOKING
If you wish to program a new cooking, the
previous cooking must be reset by pressing
button 1 for 3 seconds, after which the
cooking mode LEDs flash to indicate it has
been reset.
5.7 • SAVING THE COOKING MODE
If you wish to save the cooking, press knob
10 for 3 seconds.
The first free program will appear on display
7, select the desired program number by
turning knob 8 and confirm by pressing
knob 8.
5 • MANUAL SETTINGS FOR COOKING
WITH UP TO 4 CYCLES IN SEQUENCE
To Next Page
Loading...
Need help?
General