16
6.1
•
SWITCH ON THE OVEN
Press button 15 for 3 seconds. Whenever
a symbol appears in the anomalies display
(display 7-9) see the “Selfdiagnosis and
anomalies key” chapter.
6.2
•
SELECT THE PROGRAM
Press the Recipes button 6, the display will
show [ACC], turn the knob 8 until [Pro]
is displayed and confirm by pressing the
knob 8.
Turn the knob until the first free program
is displayed (cooking mode LED flashing
and also program number on the display 7
flashing) and confirm by pressing knob 8.
Caution
The program is “new” when the LEDs of the
cooking mode buttons and the program
number flash on the display 7.
The program is “busy” when one LED of the
cooking mode buttons and the program
number on the display 7 have a fixed light.
6.3
•
SELECT
The cooking mode buttons LEDs flash:
press the button of the desired cooking
mode (2 - 3 - 4). The selected cooking
mode LED will remain on with a fixed light.
6.4
•
SET THE TEMPERATURE OF
CYCLE 1
Turning knob 8 sets the cooking
temperature, which is shown on the
relevant display.
6.5A • SET THE TIME OF CYCLE 1
The time display shows [InF].
Turn knob 10:
to the right to set the cooking time;
to the left to set infinite time, [InF] thus
utilizing the first cycle as preheating.
Or
6.5B • SET THE CORE PROBE
FOR CYCLE 1
Refer to “Setting the core probe”.
6.6
•
SELECT CYCLE 2
AND THE FOLLOWING ONES
(UP TO 4 CYCLES)
Press the cycles button 1, the second
flashing LED (2) switches-on on the
cycles button. Proceed with setting as per
paragraph 6.3. If other phases are desired,
follow the same sequence.
6.7
•
SAVING THE PROGRAM
Hold button 1 down for 3 seconds, display
7 shows [REC], confirm memorisation by
pressing knob 8.
The program number where the cooking
mode has been saved is shown on the
display 7.
6 • ENTERING AND SAVING A PROGRAM
OPERATIONS
To Next Page
Loading...
Need help?
General