4. Fourth screen shows [t 2.1%] which is the Temperature Coefficient. The
meter can be customized with different Temperature Coefficient values
from 0.0 to 3.0 %/°C in the Advance Set-up mode. Default value is 2.1
%/°C.
5. All LCD segments will light up for 2 seconds, and then advance into the
measurement mode.
6. The meter is ready to measure conductivity or TDS.
Change Conductivity/ TDS óTemperature Measurement Mode
To switch between the Conductivity/TDS measurement mode and
Temperature measurement mode, press the MODE button.
The customized annunciator will indicate the measurement parameter.
13
To Next Page
Loading...
