244
– Failed connection of actuators: if
the control signal is failing, the actu-
ators will be brought back to the
position of maximum lowering per-
mitted for the light beam
– control unit failure: depending on
the type of failure, the system can
remain in the position where it was
when the failure occurred, or set
itself for the maximum lowering per-
mitted for the light beam
– voltage drop: when voltage falls
below 9 V, the system remains in the
position where it was when the fail-
ure occurred.
HEADLAMP ORIENTATION FOR
LEFT-/RIGHT HAND DRIVE
The car headlights are equipped
with Bi-Xeno lamps with high light-
ing power; therefore, when you trav-
el from a country with right-hand
drive to one with left-hand drive, or
vice versa, dipped beam headlight
orientation must be modified.
This operation is necessary to avoid
dazzling the vehicle coming from the
opposite direction, as well as to opti-
mize road edge illumination.
To carry out this opera-
tion, contact a Lancia
Dealership.
When you go back to
your country of origin,
remember to have the
dipped beam headlight orienta-
tion modified again.
To Next Page
Loading...
Need help?
General
