Lancia Thesis User Manual

307
WITH AN ARM HOIST OR A
SHOP JACK
The car can only be jacked up by
positioning the jack arms or the shop
jack in the areas shown in fig. 84.
An incorrectly posi-
tioned jack may cause the
car to fall. Do not use the
jack to lift loads exceeding those
indicated on the label attached to
the jack itself.
Be very careful not to
squeeze the brake pipes,
the fuel pipes or the side
member ribbing.
fig. 84
L0A6026b
JACKING THE CAR
WITH THE JACK
See “If a tyre is punctured”, in this
chapter.
Please note:
– the jack weighs 2.100 kg;
– the jack requires no adjustments;
– the jack cannot be repaired. If it
breaks, it must be replaced with a
new jack.
The jack should only be
used to change a wheel on
the car for which it was
designed. It should not be put to
other uses or employed to raise
other models. Under no circum-
stances should it be used when
carrying out repairs under the
car.

Lancia Thesis Specifications

General

Brand	Lancia
Model	Thesis
Category	Automobile
Language	English