Lancia Thesis User Manual

68
COMFORT SEATS
Side Comfort seats are fitted with
independent control buttons for
heating, lumbar adjustment, mas-
sage and adjusting function; these
controls are located inside the arm-
rest.
The armrest compartment houses
also the button for moving the front
passenger seat and the button con-
trolling the electric sunshade.
Controls are operative in one of the
following conditions:
– ignition switch to MAR
– for approx. 1 minute after
removing the ignition key or turning
it to STOP
– for approx. 3 minutes with key
removed or turned to STOP and
with door open.
Armrest compartment control but-
ton layout is as follows (fig. 56):
A – Buttons for lumbar adjustment,
massage and right-hand seat adap-
tive function
B – Button for right-hand seat
heating
C – Buttons for lumbar adjustment,
massage and left-hand seat adaptive
function
D – Button for left-hand seat heat-
ing
E – Button for moving front pas-
senger’s seat
F – Electric sunshade control but-
ton.
IMPORTANT To allow system
automatic configuration, press the
buttons for about 2 seconds to acti-
vate the required function.
Right-hand seat adjustment
(fig. 57)
1 – Lumbar support increase
2 – Lumbar support decrease
3 – Massage activation
4 – Massage deactivation
5 – Adaptive function on
6 – Adaptive function off
This device makes it possible to
vary back support and improve
comfort. Press button 1 to increase
the support and button 2 to decrease
it.
The massage function reduces the
stress specially during long journeys.
Press button 3 to start the massage
and button 4 to stop it.
fig. 56
L0A0312b
fig. 57
L0A0311b

Lancia Thesis Specifications

General

Brand	Lancia
Model	Thesis
Category	Automobile
Language	English