To Next PageTo Next Page
Need help?Do you have a question about the LANDTEC GEM5000 and is the answer not in the manual?
General| Gases Measured | CH4, CO2, O2 |
|---|---|
| Power Source | Rechargeable battery |
| Measurement Range | CH4: 0-100%, CO2: 0-100%, O2: 0-25% |
| Resolution | 0.1% |
| Protection Rating | IP54 |
| Operating Temperature | -10°C to +50°C |
| Battery Life | Up to 10 hours |
Explains safety symbols and warnings used in the manual.
Details essential safety guidelines for using the gas analyzer.
Covers specific instructions for safe operation and hazardous area considerations.
Explains the LSGAM software for managing GEM5000 data and configuration.
Step-by-step guide to installing the LSGAM software and drivers.
Details how to connect the GEM5000 to a computer via USB or Bluetooth.
Guides users through creating and managing projects within LSGAM.
Explains how to configure and manage Device IDs for sampling points.
Details the process of adding new Device IDs in LSGAM.
Process for uploading selected IDs from LSGAM to the GEM5000.
Overview of how to configure instrument settings via LSGAM.
How to configure audible alarms for gas parameters.
Process for downloading collected readings from the instrument.
Describes the primary screen for viewing gas measurements.
Explains how warnings and errors are displayed and what they might indicate.
Settings that control how the instrument performs measurements and tasks.
Procedure for performing field calibration (zero and span checks).
How to define alarm conditions for specific gas readings.
Essential pre-measurement checks to ensure accurate data collection.
How to toggle between GEM and GA modes of operation.
Using GEM5000 for gas and flow measurements with flow devices.
Detailed workflow for taking gas and flow measurements, including GPS and system pressure.
Guidelines on how often field calibration should be performed.
Information on selecting and using appropriate calibration gases.
Procedures for preparing the analyzer and gas supply for calibration.
Performing gas checks and calibrations using predefined or custom gas mixes.
How to add or remove custom gas mixes for calibration.
Resets the analyzer to factory settings, clearing user calibrations.
Instructions for installing serial communication drivers for Windows.
Instructions for establishing Bluetooth connectivity with the instrument.
Safety instructions for using the instrument, provided in Spanish.
