* 09/1_/__
* 09/11/__
* 09/11/1_
* 09/11/12
Press the ‘Enter’ key to confirm/accept data keyed.
Any mistakes can be corrected using the ‘Delete’ soft-key which will delete the last digit
typed. Alternatively, the sequence can be retyped before the ‘Enter’ key is pressed and
the existing numbers will be pushed off the screen.
Note: The instrument will not allow invalid data to be entered; invalid data should be
deleted and re-entered.
6.8 Instrument main gas read screen
The ‘Main Gas Read Screen’ is considered to be the normal operating screen and all
operations are carried out from this starting point.
The actual data shown on this display will depend on the version of the instrument and
the options that have been selected. In general, all of the main readings will be shown.
Figure 10—Main Gas Read Screen-change screen
Main Gas Read
6.9 Physical Storage
The analyzer should not be exposed to extreme temperature. For example, do not keep
the analyzer in a hot truck. When not in use analyzers should be kept in a clean and dry
environment, such as an office and protect the analyzer with either the soft carry case or
store in the hard carry case provided with the instrument.
The instrument should be discharged and fully charged at least once every four weeks,
regardless of indicated charge state. Allowing the instrument to sit for longer than
four weeks without charging it is likely to cause discharge of the batteries to a
point where the batteries will NO LONGER BE ABLE TO TAKE A CHARGE. Such a
discharge will require a factory service and battery replacement.
Page 58 Copyright LANDTEC North America, Inc. V1.13
GEM5000 gas analyzer 5K-MNL-GEM5000
To Next Page
Loading...
