GEM5000 gas analyzer 5K-MNL-GEM5000
Figure 21—Gas Check
3) For more information about the Gas Check Menu please refer to section 9.0
– Calibration.
4) Select soft-key ‘Exit’ to exit operation settings and return to the main screen.
7.4.3 View data
This option enables the operator to view the readings collected and stored
on the instrument. Readings may be downloaded to the LANDTEC System
Gas Analyzer Manager (LSGAM) software if further analysis is required.
1) Select the ‘Menu’ button on the front of the analyzer to display the ‘Device Settings’
menu. Press the soft-key to display ‘Operation Settings’.
2) Select ‘Key 3 – View Data’ and the following screen is displayed:
Figure 22—View Data
Note: Depending upon your instrument’s configuration, there may be empty rows or different gases where
Figure 22—View Data shows a highlight over CO, H2 and H2S.
3) Browse through the readings by selecting ‘Key 4 – Scroll left’ and ‘Key 6 – Scroll right’ on the
analyzer. Once at a particular reading, select ‘Key 2 – Page up’ and ‘Key 8 – Page down’ to
show more detail for that reading.
LANDTEC Page 73
To Next Page
Loading...
