After successfully creating projects, IDs, and setting appropriate instrument settings, the instrument is
ready for field use. When used in the field, readings are collected and stored within the instrument’s
memory. The readings consist of the measured, input, and calculated parameters such as CH4, CO2, O2,
Gas Temperature, Flow Rate, etc. These readings must be downloaded from the instrument to be
reviewed on the computer and stored for review at a later time. This section of the Operation Manual
reviews the process of downloading and storing readings from the instrument.
When the instrument is initially detected by the LSGAM software, the Get Readings
button will activate if there are readings in the instrument to be downloaded. Readings
will be highlighted based upon the following:
Online Project: If the readings were taken against an ID belonging to an On-Line Enterprise
To Next Page
Loading...
