LANDTEC GEM5000 - Instrument Connection Points

P
Serial Number
Unique identification for the instrument.
Verification of the serial number will be required if
Technical Support assistance is needed.
Q
Part Number
Manufacturer part number.
R
Certification Number
Displays instrument certification information.
Page 22 Copyright LANDTEC North America, Inc. V1.13
GEM5000 gas analyzer 5K-MNL-GEM5000
S
Recalibration Due
The date displayed is the date the instrument
is due to be calibrated.
4.4 Instrument connection points
Top view:
A B C D E F
Figure 3—Connection Points
Ref:
Connection Point:
Function:
A
Connector & Dust Cap
Attach the USB cable for PC-to-
analyzer connectivity.
B
Inlet Port & Static Pressure Port
(White port)
Attach the sample tube to take a gas sample.
Also used to measure the static pressure.
C
Differential Pressure Port
(Blue port)
Attach the sample tube to measure
differential pressure.
D
Connector & Dust Cap
Attach the temperature probe while
taking readings.
Attach the wall charger to the analyzer
for charging.
E
Gas Outlet Port
(Yellow port)
The gas outlet port is the point at which
the sample gas is expelled. Tubing may
also be attached to the port.