Setup Records Supplemental Information
E-12
Disconnect Mode
In Disconnect Mode, DTRdrop either drops the connection or isignored. Use thefollowing
table to select Disconnect Mode Options:
*DTR is an output signal on a DTE serial port. The DTE devices are the CoBox Micro, CoBox Mini, and
CoBox Mini100. On DTE devices, use DCD (input) instead of DTR.
Note: See Binary to Hexadecimal Conversion on page E-18 for more
information on converting binary values to hexadecimal format.
Flush Mode (Buffer Flushing)
Using this parameter, you can control line handling and network buffers with connection
startup and disconnect. You can also select between two different packing algorithms. Use
the following table to select Flush Mode options:
Table E-10: Disconnect Mode Options
Option Bit76543210
Disconnect with DTR drop 1
Ignore DTR 0
Telnet mode and terminal type setup 1
Channel (port) password 1
Table E-11: Flush Mode Options
Function Bit76543210
Input Buffer (Serial to Network)
Clear active connection (from serial) 1
Clear passive connection (from network) 1
Clear at disconnect 1
Output Buffer (Network to Serial)
Clear active connection (from network) 1
Clear passive connection (from serial) 1
Clear at disconnect 1
Alternate Packing Algorithm
Enable 1
To Next Page
Loading...
Need help?
General