Network
E220 Series Cellular Router User Guide 80
Parameters Description
Modem init timeout Enter the maximum wait time in seconds for the modem to become
ready.
The default modem initiation timeout 20 seconds.
Use default gateway Click to configure a default gateway route.
None of the gateway routes are configured by default.
Use gateway metric Enter the gateway metric.
The default metric is 1.
Use DNS server advertised by
peer
Allows the router to advertise the DNS server address.
Use DNS server advertised by peer for 3G interface is checked by
default.
LCP echo failure threshold Presume peer to be dead after configured LCP echo failures. Use 0
to ignore failures.
LCP echo interval This is time the router should wait before sending an echo request to
check whether the link is alive or not.
The LCP echo interval by default is 20 seconds.
Inactivity timeout The Router will wait for the LCP echo request response for the LCP
Echo interval defined after every attempt. It declares LCP link as
closed if it does not receive response after this defined period of
attempts
Use 0 seconds to persist the connection.
Table 10.1-7: Advance Configuration of CELLDHCP Interface
To Next Page
Loading...
Need help?
General