Lantronix MatchPort - Basic Configuration; Figure 3-4. Serial Recovery Status Window Example for a Matchport AR; Figure 3-5. Serial Recovery Results Window

3 dBUG Boot loader
Linux Software Developers Kit (SDK) User Guide 21
Figure 3-4. Serial Recovery Status Window Example for a MatchPort AR
8. Click OK when prompted. The dBUG boot loader should now be installed on the target.
Figure 3-5. Serial Recovery Results Window
Basic Configuration
1. Connect an RS232 cable between your host computer COM1 and any of the MatchPort AR
(CON1 on the eval board), XPort Pro (Port A on the demo board), EDS1100 (Serial), or
EDS2100 (Serial 1). Serial port settings are as follows:
baud rate: 115200
data length: 8
parity: None
stop bit: 1
flow control: None
2. Turn on the target.
3. If autoboot starts, press any key to stop autoboot.