Lantronix SLC 8000 Series User Manual

15: Command Reference
SLC™ 8000 Advanced Console Manager User Guide 392
Parameters
name <Probe Name>
starttime <now|HH:MM[:SS][MMDD]|afterHH:MM:SS>
operations <Number of Operations to Perform>
frequency <Seconds between Operations>
packets <Number of Packets to Send>
interval <Milliseconds between Packets>
timeout <Milliseconds to Wait for Response>
host <Destination IP Address or Name>
port <Destination Port>
precision <milli|micro>
datasize <Payload Data Size in Bytes>
verifydata <enable|disable>
codec <g729a|g711alaw|g711mulaw>
tos <none|Type of Service>
interface <none|eth1|eth2>
nameserver <IPv4 Address>
Description
Edit an existing probe.
set perfmon delete
Syntax
set perfmon delete <Probe Id or Name> [data <all|# of Sets to Keep>]
Description
Delete a probe, or delete all operation data for a probe, or delete all but the most recent operation
sets for a probe.
set perfmon state
Syntax
set perfmon state <all|Probe Id or Name> action <restart>
Description
Set the running state of all probes or a single a probe.

Lantronix SLC 8000 Series Specifications

General

Brand	Lantronix
Model	SLC 8000 Series
Category	Switch
Language	English