Lantronix SLC 8000 Series

6: Basic Parameters
SLC™ 8000 Advanced Console Manager User Guide 82
Configuring IP Filters
The administrator can add, edit, delete, and map IP filters.
Note: A configured filter has no effect until it is mapped to a network interface.
See Mapping Rulesets on page 80.
To add an IP filter:
1. On the Network > IP Filter page, click the Add Ruleset button. The following page displays:
Figure 6-5 Network > IP Filter Ruleset (Adding/Editing Rulesets)
Rulesets can be added or updated on this page.
2. Enter the following:
Ruleset Name Name that identifies a filter; may be composed of letters, numbers, and hyphens
only. (The name cannot start with a hyphen.)
Example:
FILTER-2