Laski LS 150 D - Pre-Operation Checks

2 4
valid only for LS 150 DW: - before putting the machine aside for a longer
time/storage check out the cooling liquid – it should be mixed for -20°C.
Pay attention to it particularly in winter time.
Before Putting into Operation
Before Putting into OperationBefore Putting into Operation
Before Putting into Operation
- Before the first putting into operation check up the machine for contingent
damages and completeness after its transport and storage.
- Check out tightening of bolted joints, especially guards, grids and
completeness of other parts.
- Check out movability of turnable parts (loading chute, discharge duct etc.).
- Check out work safety labels for completeness and legibility. Replace any
damaged and illegible label, if necessary.
- Grease bearings and sliding parts.
- Check out the engine oil level with a dipstick and refill if necessary. The oil
level must be between both marks (MIN and MAX).
- Check the suction line for tightness – any leakage reduces chipping
performance essentially.
- Check the fuel line for tightness and electric wiring for completeness.
- Plug the traffic lights and check their function.
- Do not try to repair the machine if it is beyond your competence. Any
servicing, especially of rotating parts, should be carried out by authorised
persons only.
- Check out condition of blades. Replace them if worn or damaged.
- For replacement use always original spare parts. Parts, such as rotors,
should be balanced properly.
- All blades should be replaced always at the same time as a set. Pay
special attention to their fixing bolts. Replace them if worn or damaged.
- Avoid spillage at filling oil or fuel. Use always a proper filling funnel. If any
fuel or oil is spilled or overflowed then wipe off the spots immediately.
- Do not use petrol or similar inflammable matters as a cleaning agent.
- Max. capacity of the fuel tank is 20 l. Minimal fuel charge is 5 l.
- For engine operation use Diesel fuel only (winter Diesel fuel according to
season).
- After storage check out the battery. Recharge it if necessary.
- Plus and minus poles should be connected just before starting.
- It is strictly forbidden to do any technical changes on the machine.
- If any adjustment is required, do it always at standstill only. Remember
blocking the wheels against unwilling motion.
- Check out the air filter, especially at work with very dry and rotten
materials. Empty the pre-cleaner element regularly.
- Check out condition and proper tightening of V-belts.
- It is strictly forbidden to start the chipper with removed hoods and guards.